Ford may change the contents without notice and without incurring obligation. Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. Lift right side off of its hinge. Position the child safety seat in the Regular Cab center front seat. For a mounting pressure more than 20 psi greater than the maximum pressure, a Ford Dealer or other tire service professional should do the mounting.
For questions or comments, please contact HomeLink at www. Octane recommendations Do not be concerned if your engine sometimes knocks lightly. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. The emission system heats up the engine compartment and exhaust system, which can start a fire. Direct the outer instrument panel vents towards the side windows. Be sure that the belt webbing is not twisted.
Vehicle line, series, body type 4. There should be no more than one inch of movement for proper installation. Booster seats position a child so that safety belts fit better. Refer to the Maintenance product specifications and capacities section in this chapter. Please refer to the Body Builders Layout Book for instructions about the appropriate installation of additional equipment. Refer to Fuel filler cap in the Maintenance and Specifications chapter.
If the arbitrator has decided in. If the safety seat is not anchored properly, the risk of a child being injured in a crash greatly increases. To obtain reimbursement information, U. Pull bulb straight out of socket and press in the new bulb. To auto eject up to 6 discs, press and hold until the system begins ejecting all loaded discs. Attach the new wiper to the wiper arm and press it into place until a click is heard. Remove the jumper cable from the ground metal surface.
Go to the front of the vehicle and release the auxiliary latch that is located on the front bumper under the grill. The system monitors and tailors the air bag deployment based upon safety belt usage. Adjust your head restraint so that it is located directly or as close as possible behind your head. We are going to help you to get articles 2008 Ford King Ranch Owners Manual you're looking at some of our content which might be suitable as you are looking for the material. Check to see if the anchors hold the seat in place. The spare tire carrier will not allow you to overtighten. If this is not possible, wait a short period for the engine to cool.
Use of these systems may result in vehicle starting problems and a loss of security protection. For additional information, refer to Understanding the gearshift positions of the 4—speed automatic transmission in the Driving chapter. Not intended for use on dry pavement. Ford Motor Company shall not be responsible for any such programming changes. Steam and scalding liquids released from a hot cooling system can burn you badly.
These ratings are listed in the following chart. If the battery has been disconnected and reconnected, refer to the Battery section of the Maintenance and Specifications chapter. Power Sliding Back Window if equipped To operate the power sliding back window, the ignition switch must be in the Run or Accessory position. Power steering fluid reservoir 5. Failure to properly maintain your tire pressure could increase the risk of tire failure, loss of control, vehicle rollover and personal injury. Refer to Fuel filler cap under the Fuel Information section in the Maintenance and Specifications chapter. This feature will remove ice and snow from the side view mirrors.
Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. If failure repeats, bring your vehicle to your authorized dealer to have the new spare key s programmed. To reduce the risk of injury, make sure children sit in the back seat where they can be properly restrained. Wait until the safety belt warning light turns off. The flow of fuel through a fuel pump nozzle can produce static electricity, which can cause a fire if fuel is pumped into an ungrounded fuel container. They may seriously hurt themselves.
Check the fuel filler cap for proper installation. For more information, refer to Filling the tank in the Maintenance and Specifications chapter. Ford recommends the use of a digital or dial-type tire pressure gauge rather than a stick-type tire pressure gauge. Bring the vehicle to a complete stop. Pull control to release seat cushion. The normal operating temperature can be reached after approximately 20 miles 30 km of driving. Use only Ford recommended replacement fasteners.
Check the coolant level and replenish if low. Once loaded, the first track will begin to play. Buckle the combination lap and shoulder belt. Failure to properly wear your safety belt will increase your risk of injury. See Warning lights and chimes in the Instrument Cluster chapter for more information regarding the warning lights.